Welcome to the Growery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!
Materials: 3/8 Barb 90* - 1/4 npt fitting $3 3/8 clear vinyl hose $4 7/16 drill bit (already owned) 1/4 NPT tap around $10
Directions:
Drill hole at the bottom of your bucket/container with required drill bit.
Then run the tap through there, if your tap is sharp you should have no problem spinning it by hand.
Attach desired length of hose (DWC guys will obviously want their's the height of the container while hempy's can use a considerably shorter piece)to the barb fitting.
Thread into bucket and done, you may want to use some pipe tape or pipe "dope" to ensure a leak free seal. Also, these are NPT threads so they have a taper for sealing purposes, so make sure you thread into the bucket not too much, but until it gets snug. Three to four turns should be plenty.
Where ever the level in the bucket wil be transferred to the tube, go fill it up and check it out.
While you may be thinking its just novel, its dual purpose, just turn it to the side and it makes a great drain, especially valuable to those trying to flush their hempy bucket. I have heard quite a few people talk about that part being a real PITA.
Hope it helps!
-------------------- If you ain't smokin' dro, you're smokin' reggie.
Threaded
Previous
Index
Next
Some of these posts are very old and might contain outdated information. You may wish to 
Edit 
Reply 
